EPSON Interactive Pen Manual Calibration (using pen as mouse to control your PC)
If you have followed the instructions to calibrate the smart pens of your projector but still find that the interactive piece is off. Please follow these steps.
Adjusting the Pen Operation Area
If you connect a different computer or adjust the computer's resolution, the pen operation area is adjusted automatically to match your mouse pointer position. If you intend to only use a single computer with the projector, set Auto Adjust Pen Area to Off. If you will be using many computers with the projector, set Auto Adjust Pen Area to On.If you notice that the pen position is incorrect when using PC Interactive mode, you can adjust the pen area manually.
Note: Manual adjustment is not available when projecting from a LAN source.
- Project your computer's desktop.
- Press the Menu button, select the Extended menu, and press Enter.
- Select the Easy Interactive Function setting and press Enter.
- Select Advanced in the PC Interactive section and press Enter.
- Select Manual Adj. Pen Area and press Enter. You see this screen:
- Press Enter to select Yes. The mouse pointer moves toward the top left corner.
- When the mouse pointer stops at the top left corner of the image, touch the tip of the pointer with the interactive pen. The mouse pointer moves toward the bottom right corner.
- When the mouse pointer stops at the bottom right corner of the image, touch the tip of the pointer with the interactive pen.